Anycubic Photon Printer Owners 造訪社團

Printed this castle, which I am pretty sure is not hollow and I can see a large bubble floating around in the inside in uncured resin. Any idea what would cause this?

翻譯年糕

Any experiences with Photocentric DLP Black? (Opacity etc.)

翻譯年糕

After returning the previous photon for a malfunctioning screen I put my truat back on the photon and...very nice printer!! For my first test I chose a 54 mm scale dirk from dragon's lair I sculpted eons ago. Very nice indeed...I hope it lasts

翻譯年糕

Model doesn't show up?

翻譯年糕

Can anyone tell me why this looks so cloudy? Has it just not had enough time in the sun?

翻譯年糕

I bought some Monoprice Black and it comes out this very nice smoky but somewhat translucent black. It's quite nice. But is there a more opaque black available?

I'm hoping to print some pistols for GI Joe (see previous post) that I don't have to paint, because paint often comes off onto Joe's hands.

A more opaque black lets me make them with only minor cleanup after clipping the supports.

翻譯年糕

Just realised I still haven’t posted anything here yet!
So here goes.
Put a small 0.025MM print going ( bottle cap sized rebel logo ), left it to print came back to my office some time later.........
After like 50/60 prints no problems, something obviously went wrong in the slicing! ?

翻譯年糕

Sigh... Got my new screen installed. Still have the half-screen issue. Welp, it was a fun month, but I'm guessing that's it for my Photon run. We'll see what support says, but I'm not hopeful.

翻譯年糕

Completed my first print of a bust I sculpted and did a very quick paint sketch before I make improvements to the sculpt and print another.

I definitely had some z wobble problems. You can really see it on the arm in the painted pic. Could this potentially be caused by the printer not being totally stable on the counter while it was printing? Or is the only cause the internal tightening issue that Anycubic put out a video about?

翻譯年糕

Good morning folks. I've had my Photon for a week now, and have had this issue with a few prints.

Any idea what happened with this miniature's left arm? I'm assuming I needed supports for his arm and sword?

翻譯年糕