Anycubic Photon Printer Owners 造訪社團

Im back :) Used to have an I3 Mega, replaced it with a Prusa MK3, but now had an DLP itch that needed scratching Anycubic Photon ordererd from Aliexpress German warehouse, together with some resin

翻譯年糕

Doesn’t look good I hope it’s alright

翻譯年糕

Resin resin resin resin resin ??
Anycubic green (and all other colors) back in stock in German warehouse.

https://nl.aliexpress.com/…/ANYCUB…/721071_32855874599.html…

翻譯年糕

Hey guys, before i get the printer i plan to make a print cleaning kit like the one formlabs has and use IKEA plastic boxes. Is there something similar already made or are you interested?

翻譯年糕

Ok guys, I seriously need help getting my printer back up and running. Can ANYONE help me? Please

翻譯年糕

My latest 2, the head ive done already but i scaled it up a bit to get it closer to a bust size...and the figure is 55mm my largest print yet.will clean up and give them a base coat so i can see the details better. and hopefuly this will help with getting a better idea to creating details in future and what can be achieved.

翻譯年糕

I'm going nuts with Photocentric. Not only was their flexible resin complete trash, but also the high tensile one is a pain. It's really tough and tougher than anything else I've seen. However it's causing weird print failures. Look in the attached image. The bridges above the slits in the print fail randomly on some but not other items. It's pretty random. I increased exposure time but it has zero influence on that behavior. I suspect it's related to pigment settling down. Always after the print, pigment has settled in weird patterns at the vat bottom and the remaining liquid is clear. Does anybody have any tips? Manual mixing in between?

翻譯年糕

Do you think it's enough resin to start printing today?

翻譯年糕

Anybody tested the XYZ Nobel resin (clear) in the Anycubic? I can't find any experiences.

翻譯年糕

Major increase in quality and huge increase in toughness after switching from f2d to anycubic grey. Afterwards I saw that I could have used less than half the number of supports but still a pretty good result.
As usual I use a combination of Meshmixer and Anycubic slicer supports.
layer 0.05 @ 9 seconds normal exposure, 70 seconds bottom exposure with 4 bottom layers.

翻譯年糕