管理員
統計數據
原文網址 Dustin Scott 2018-05-15 06:25:08
Received my photon! Problem is, the build platform was loose in the unit, rattling around...
Scratches everywhere on the platform! And... to top it off, the tools were not in the box ?
Unit powers on, LCD isn't damaged, and I'm willing to test it out. Anyone else have those issues?
原文網址 Nick Adam 2018-05-15 05:42:58
Any feedback what could have caused this layer shift? Pic of orientation I used too, B9Creator
原文網址 Todd McKechnie 2018-05-15 05:30:22
Little more.... still lots of time left.
原文網址 Mark Moore 2018-05-15 05:26:24
Maybe this has been asked before (hopefully not) however after some searching I cannot seem to find this ring.Has anyone seen it on thingverse, shapeways, cults3d etc? if so, will you point me in the right direction? Thank you
原文網址 George Mouzourakis 2018-05-15 05:00:12
Greetings to all.I'm considering to buy a photon but prefer the options nanodlp has to offer.I know you can fit it in a whanhao D7 so i'm here to ask if photon has hdmi in for the lcd.Thank you all in advance
Vinicius Silva 2018-05-15 05:10:00
George Mouzourakis 2018-05-15 05:20:36
George Mouzourakis 2018-05-15 05:23:38
Audrius Verbavičius 2018-09-24 04:11:41
原文網址 Brian Jason 2018-05-15 04:34:49
forgot to fill up the vat while there's a print going on ... before leaving to work. About 11hr print I started last night. so my question, how much wood could a woodchuck chuck if a wood chuck could chuck wood?
Happy Monday!
原文網址 Fletcher Kinnear 2018-05-15 04:22:26
Okay. My prints keep peeling off of the plate. What are some solutions? Higher cure time? More base layers? How does that even work exactly? I've struggled to find literature that explains the basic science of the bond between part and plate.
原文網址 Jon Weger 2018-05-15 04:20:51
Getting tired of your shit 3dOkay. Nearly every print has this issue. They start of fantastic, and the end of the prints just go to hell. So frustrating! That's a half liter I went through and at the end of it, I got a small handful of usable prints. I really think the issue is with the settling and separation of the resin in some way. Prints are hollowed to 2mm, have vent holes, good supports, etc. Unless the black happens to be better...which I doubt. I can't in good faith recommend this one as a general use resin. I'll run the same print tonight in Anycubic Green to compare.
I love cheap stuff that works, unfortunately, this one doesn't fit in that category.
原文網址 Kevin Rank 2018-05-15 04:02:26
Finally got my Unboxing and Preview page up and running. Hope you enjoy it! I doubt there is anything new for members of this group.
原文網址 Todd McKechnie 2018-05-15 01:56:10
9 hours of waiting.... long prints hurt my head...lol
討論主題
發文排行榜
回文排行榜
熱門關鍵字