Anycubic Photon Printer Owners 造訪社團

Hi everybody. I took the printer for 3 days and printed 10 times, edited many parameters but all were faulty. I suspect the machine is wearing faults in the lead screw shaft (in the video). I want to go for warranty, so I need to make sure it is the manufacturer's fault. Expect everyone to check your machine and give me advice. Thanks very much !!!

翻譯年糕

hi everyone!! here's a finished from last week i think. about 80mm tall. there are some holes because the wall are too thin as this was intended to be a 5 inch figure, but i decided to scale him down to save on resin.
this was printed in parts btw - head, torso, legs, arms and 2 part base.
cheers!!

翻譯年糕

Is that tiny screw supposed to be sticking out like that or should the thin aluminium piece sit flat on the surface of the platform??

翻譯年糕

I want To replace the fep sheet. How thick should the fep be? 0.15-0.2mm or could it be thinner?

翻譯年糕

Got my photon in yesterday set it up and got the test cube to print first go. Thanks for all the helpful posts here, it made getting printing quick and fun. Running another print from a friend now. Lots of small words to see how fine it can print.

翻譯年糕

Photocentric Clear Frim

LZ: 0.05 | EL: 30 s | OT: 6.5 s | EB: 160 s | BL: 8 | RT: 20ºc

PRICE: 70.eur/Kg | RINSE: Warm Soapy water | SMELL: Almost unoticed

The test i did with the multiexposure test method, did get me in the ballpark

The minimum setting that it gave me was 5x5s so i used 30 sec at first i set the base layers 5 what i used for the anycubic green 5x80s and it went trough the LCD, the i change it to 160 but you can see the effect of it in the legs

Washed up well with warm water and kitchen soap, let it cure in the sun for abour 30min

the details in the ears look to me overexposed I can probably get away with 25s per layer.

翻譯年糕

can anyone share me a tutorial about resins? set layers etc?

翻譯年糕

I can't manage to get my prints stick to the build platform. They always end up as flat pancakes on the bottom of the tank :( Any suggestions? I am using Anycubic Basic resin (Gray) 405nm. 8 bottom layers with 60 s exposure. 15s for other layers

翻譯年糕

Hello! anyone have a good tutorial for layers/times etc?

翻譯年糕

Somebody made a written explanation of Flint Read Leveling.

Where can I find it plizz ?

翻譯年糕