Thanks for letting me be a part of the group. I've had my Photon for 3 days and have only gotten about 3 prints done. All are looking great. Except I think I the spot where support contacts the print are what my wife refers to a 'Nubtactular'.
I assume I need to make the support contacts smaller and use maybe less supports? An Xacto knife and my needle files seems to do the trick in cleaning it up. I am just looking for advice to lessen the amount of support nubs.
Also after curing the 3 prints I did I noticed in the corners and recesses the print has a bit of white now (as opposed to the green/teal of the starter resin) If this because IPA was still on the print when I stuck it inside my UV lamp for cure?
Thanks in advance!
翻譯年糕