Anycubic Photon Printer Owners 造訪社團

28mm scale Humanoid turtle miniature- my sculpt. Love the photon!

翻譯年糕

Hello thanks for add me.
Can you tell me if printer is Good for jewelry? What is the definiton in X, Y and Z REALLY?

翻譯年糕

Thanks for the add, Anycubic photon just turned uon Saturday (UK) but USB not working so have to wait until Monday and hopefully get sorted...hoping to learn from some of the people on here...fingers crossed...any other UK user on here...as i`m sure i`l need resin at some point...

翻譯年糕

Photocentric3d clear flex resin... How long to post UV cure? I saw in previous posts that you'll know it's cured when you can't scratch it anymore. But even after hours of post curing, I can still scratch the surface. Is it just the nature of this resin because it's flexy and softer?
Pictured: photocentric3d clear flex resin with turquoise pearl pigment mixed in on the left; with additional pinch of black pigment mixed in to get richer blue on the right

翻譯年糕

Running my first prints at 0.04. Still need to get the new firmware installed....

翻譯年糕

OK - now i tried how good my 3D scanning setup is :) - the model is 27mm tall - Pictures are: original - scan - print - print primed - and then backside original - scan - print primed :) ( the print is just 0.05mm layer - so it could get better :) )

翻譯年糕

Hey everyone! New to the group! Just had a question,
1. What other resins have people used that are cheap
2. Has any one started making their own resin?

I saw also that their was a thought that because alot of resins dont work with the photon, that some people were thinking it wasnt 405 nm lights?

Any body ever measure the lights?

翻譯年糕

I am some what concerned about the 70 degrees. I live in Denmark and it is only on the best of days above 70. So how low can I go?

翻譯年糕

I'm having major warping problems printing this large model. Adding ribs around the screen didn't improve at all. The bottom part is perfect but the top comes out warped everytime. Fun to do industrial red. .1mm layer height. Any recommendations? Maybe printing at .05mm would improve?

翻譯年糕

So what would cause the print to become unattached from the build plate and become stuck to the FEP instead? Before I went to bed all the pieces were on the plate and stuck seemingly well. :-/

翻譯年糕