管理員
統計數據
原文網址 Chad Elstad 2018-04-26 22:46:53
Anyone tried this resin? Water washable? Luvantix 3dmaterials water washable clear resin
原文網址 Zach Ryan Lynn 2018-04-26 22:44:16
3 questions, is there anyway to prevent a cured piece of resin in the vat when the print is done. Also is the anycubic resin have less smell then monocure or is my vent system just doing a really good job. Also even with the plastic scrapper,if I light removed said piece of cured resin it doesn’t scratch the fep it’s almost like it dents it slightly.
原文網址 Roger Cejalvo II 2018-04-26 22:27:29
3D-okay resin back in stock for us USA people. I just ordered a 3 pack.
原文網址 Da Dornta 2018-04-26 21:59:15
Any ideas what caused this to my Eiffel Tower? Anycubic white resin, default settings after re-leveling and setting my Z=0.?
原文網址 Rick Graham 2018-04-26 21:55:52
For those who have a air filter setup can you post a picture of the back of your printer? I want to see what others came up with so that I can get printing Saturday.
Thanks :)
原文網址 Sean Latto 2018-04-26 21:50:15
And I'm back...just a little top fill 'n' cure required.. start of a large model.... ? ? ?
原文網址 Richard Groenendyk 2018-04-26 20:49:01
Man been thinking about trading me photon for a cr10 or toronado
原文網址 何麥可 2018-04-26 20:32:01
Yellow seems to be working better than orange - especially in avoiding the duck bill warpage at the nose of the primary hull.
原文網址 Olle Sköld 2018-04-26 20:27:53
Hi! Anyone here built their own curing station? I haven’t started using this printer yet but want to source gomponents to build a curing station and I’m wondering which UV-lights to use? when looking at a local hardware store, they don’t state the wavelength for their UV-lamps, are most in the same range or do I need to purchase special ones? thanks!
原文網址 Tom Campbell 2018-04-26 19:33:50
Hi all, thanks for the add. I need some assistance please. First print no good, it was not levelled correctly and was stuck to the film in the vat. Levelled it again and hey presto perfect ? 1st pic. Loaded Star Wars Rebel ring, I thought I placed it on the build plate correctly with the correct supports. But it failed. Some was stuck to the build plate and some was stuck again to the film in the vat? So I emptied the vat and gently scraped off the failed prints. Then I noticed a weird indentation in the film and some small holes. I didn't press to hard to get the failed prints off. Very concerned, Is there a great guide to placing the model and supports anywhere? Your help is appreciated ?
討論主題
發文排行榜
回文排行榜
熱門關鍵字