Anycubic Photon Printer Owners 造訪社團

Should the next Photon or even this one have a resume print option either built in or as an optional upgrade so we can resume an interrupted print due to power failure or such?

I WILL BRING THE RESULTS TO THE ATTENTION OF ANYCUBIC AFTER WE HAVE ENOUGH RESULTS :D

翻譯年糕

It's really not easy to impress me. But this shit just blown my mind. I can't believe I printed it myself...

And it's not even primed yet...

翻譯年糕

OK had a power cut last night so had to re level the bed, Used my method and this is the result, Just set it and walked away.

Anyone for ribs?

Notice there are no supports and all stuck to the plate perfectly for a 10 hour print that's why levelling is essential folks :D

翻譯年糕

Good place to get fep and a video on install?

翻譯年糕

Screams at meshmixer. for messing up the models during making holes. was in a rush so used its holes rather than do my own. :( Screams at meshmixer. for messing up the models during making holes. was in a rush so used its holes rather than do my own. :( 翻譯年糕

I just received this screen protector from Amazon. The specs looked good and it was only $8.99 so I thought I would give it a try. Fit was great, came with a “sucker”, a little suction cup that helped to get it aligned.
Installation tips: I blew out the interior with compressed air. I placed a piece of blue tape so I could line up the screen. Clean the lcd, then place the screen, lining up the side with the tape and lower it down (suction cup is on opposite side). If you see you trapped dust underneath, lift it back up, rinse with water and blow dry (don’t touch the adhesive side). Try again. The suction cup as a little handle worked great inside the limited space.

翻譯年糕

Do you guys have bubbles appear inside the print (nowhere on the outside) when you print something cylindrical and in clear resin (you wouldn't know if it weren't clear because you won't be able to see the inside)? It happens to me only when I print in the middle of the vat and not when I print near the edges. I'm assuming it's because of how the fep film is tensioned.

翻譯年糕

With a transparent paint ! It’s beautiful ?

翻譯年糕

Successful prints, bad camera. Heroforge Paladin example, Goliath barbarian from Thingiverse, and a robot technomancer I designed from HeroForge.

翻譯年糕