Anycubic Photon Printer Owners 造訪社團

This is Gerard, FEAR HIM!!!

翻譯年糕

Anyone know how to make models have sharper details? Many models are built for FDM printing. For example, I think the heroforge and PrintableScenery models seem to be too rounded for my liking. For now I'm just making my own stuff with meshmixer's make solid to have thin edges.

翻譯年糕

Does anybody have experience with Wanhao 3D-Printer UV Resin Green?
Any recommendations as far as settings go?

翻譯年糕

So my photon was working great (even with my limited knowledge on how to support stuff) then one day my print is all sideways and crazy and I noticed my screen is blown in. Anyone have this issue?

EDIT: Anycubic is sending me another screen. I just wanted to know what I did wrong here.

翻譯年糕

Hmmm... I wonder if this would work to contain the fumes and could be used to vent out contaminants.

It looks like the holes up top could be fitted with a tube of some sort, and the bottom ones can be closed off. It also looks like it is big enough to fit a few units inside.

翻譯年糕

Why is that you all post prints with the model in like 45ish°, doesn't this waste a lot of material on supports? why are you doing this?

EDIT:
NVM I just saw this, you can delete this post or have a chat about it lol

翻譯年糕

Not my first print but pretty close. I definitely need to learn how to place my supports better. I had one stuck to pretty much every wheel.

翻譯年糕

So I've watched all of the videos on supports and prepping models, but I'm still having a lot of trouble getting anything with more than a couple supports needed to print. I tried the auto-generated supports and they worked well enough to print the model to 75% when the printer malfunctioned/the sliced file corrupted one and it stopped printing, but many of the supports intersected the mode making it impossible to pull them out. I then tried making my own supports in B9, but after the base supports it stopped printing. So I tried again adding more supports. It partially printed but some of the more extreme over hangs did not stick. So what is the best way to get a model with a lot of overhangs to print well.

翻譯年糕

Hey everyone just got my photon :) one question, when I do the levelling it does not save my Z when I do the Z = 0. It stick with the old homing settings which is a bit higher

翻譯年糕

Well It's now confirmed, And I can stop going on about it, Another perfect Z wobble free print!

GRRRRRR!

翻譯年糕