Anycubic Photon Printer Owners 造訪社團

Anyone ever do a lithophane on this printer?

翻譯年糕

Over all, I feel my enclosure is successful. I could still smell a little bit near the printer while it was running, and I think it was because the fan I bought was too low power. But no where near what it was without the enclosure. I just replaced it with a bigger one that should help even more - 6inch vs. 4inch and twice the cfm. I did two prints today and both turned out well. The temp inside the enclosure matched the temp when running outside the enclosure from the prior day. So no overheating issues. No smell filled the house like before the enclosure. In fact, I couldn't smell it at all outside the room. I cut a piece of acrylic plastic to fit the inside of the window screen, then taped them together after taping the vent hookup to the hole cut in the plastic sheet. So it vents outside. I plan to get an inline carbon filter, but need more research to get the right one and a good price.
Future enhancements will be to cut a hole in the bin cover and put in a window with left over clear plastic. Having to take the lid half off to see status was annoying.

翻譯年糕

So has anyone tried the Monoprice resin yet?

翻譯年糕

After printing twice it finally dawned on me why one side was not printing correctly as the rest of the print was fine. Printing a bracelet I had it set at an angle to reduce print time but had the bottom of the bracelet sitting about 3 mm away from the edge of the build table. The bases of the supports were there but distorted and caused that part of the bracelet, about a half and inch, to be distorted it was partly on the outer edge of the vat. So my thought is the closer to the edges of the build box the tighter the FEP film is and it distorts the print. Printing is much more accurate and with no distortion the closer to the center due to the increased tension for the release of the print. Makes sense.

翻譯年糕

Greetings, there's 2 stores in aliexpress which one is the real one or are they both the same?

翻譯年糕

Pretty neat stuff going on, after my last post had a discussion on there and received the advice of using a solar powered turn table to spin while uv lights are on, and damn its spinning pretty good for only solar power. It's till has alot of work to be done and yes, cleaning lol, panels will be blacked out and painted with reflected paint anyways later. But, pretty neat idea

翻譯年糕

I ll be machining some UV blocking windows out soon. I ll have enough left over materials to do one maybe two sets if anyone is interested let me know.

翻譯年糕

I'm looking at buying the Photon this week. I have a few questions I'm hoping the community could help me with

1) Is there anything I should know before buying? (upgrades/issues).

2) What resins brands are people using? does it have to be the official resin?

3) where is the best/cheapest place to buy the printer and resin for Aussies?

翻譯年糕

Monocure rapid 'black', ok its more transparent...i'm not happy with it :/

翻譯年糕

Oh oh. Imakr just emailed me to say the Fun To Do Industrial Black is out of stock and they don't know when they will get it back in stock due to manufacturer issue.

翻譯年糕