Anycubic Photon Printer Owners 造訪社團

Einstein bust with Monocure Rapid Blue. Layer height 50 microns, Settings 15/1/60/5. The same bust on the FDM printer didn't work out as well as the DLP one did :-D

翻譯年糕

Sell Printer-friendly files STL Sell Printer-friendly files STL 翻譯年糕

Little cleaned up better.

翻譯年糕

I did something weird that actually worked. My FEP film had had it, things were starting to stick to it after about 10 prints.. I recall anytime I accidentally got pledge(furniture polish) on my floors it would be a slipping hazard for days.. So i put some on the fep inside film and wiped it down really well with microfiber until the streaks were gone.. I have gotten 3 more prints so far that look perfect and did not stick a bit.

翻譯年糕

I'm always iffy when it comes to pausing a print then resuming it... sometimes something doesn't go right or it skips a layer. But I may need to add a little more resin in my current print. Anyone has done this and had no problem?

翻譯年糕

First print actual print.... success.

I thought maybe i should have printed the test cube... but I wanted a skull.

Anycubic green resin

3 hours print

600 layers

.05mm micron

10 normal exposure

1 second off

50 bottom exposure

8 bottom layers

Auto supports

翻譯年糕

Another print done :)

翻譯年糕

So I just got my printer in yesterday and went through the bed leveling procedures. However when I press zero position it shows me the yes or no menu but I cannot press any of them. It eventually goes away but ive tried running two prints now and nothing has stuck.

翻譯年糕

not bad for a first try! Anycubic printed rings, two part silicone mold, then cast in pewter.

翻譯年糕

Printed some pillars for a 1:87 tram station. More to come.

翻譯年糕