管理員
統計數據
原文網址 David Wong 2018-04-07 15:25:03
Meshmixer support really nice. Easy to remove, Manually adding support is much easy to use and more control over it, and meshmixer support really resin saving . Since Autodoesk have a sla printer , they clearly know what they r doing the in the software side.
For Photon printer Manually adding abit more support is needed bcos it is pull-to-release type of printer, more force required . Unlike Autodoesk sla printer is slide-to-release. So imo meshmixer tent to generate less support than what Photo need.
原文網址 Scott Findlater 2018-04-07 15:02:37
https://www.facebook.com/baconinabun/posts/431962730559267
原文網址 David Culp 2018-04-07 14:56:11
I need a new LCD screen -
i was attempting to remove the vat and apparently it was stuck hard to the LCD screen, may have had some resin on the bottom of the FEP. The whole LCD screen ripped out of the printer when I removed the vat.
So, where do I get one and how much?
原文網址 Sergi Prte 2018-04-07 14:12:09
just to ordering my photon and I just see new wanhaoo d7 v1.5 likes soom similar, but with big build area, someone know something??? life is hard guys... ? ? ? ? ? ?
原文網址 Booie MAxx 2018-04-07 12:56:42
Figure I'd post my first with a print recently did, very impressived
原文網址 Ryan Mercury 2018-04-07 12:37:14
My print didnt print. The top plate was a bit lose. Hopefully that was the reason. Printing a second time. Hopefully it works
原文網址 Roger Cejalvo II 2018-04-07 11:51:38
My first full height print, it came out great the 1st time. I really need to sit down with the 3D okay resin and get their settings locked in. Print with the anycubic green resin was a lot easier.
原文網址 Flint Read 2018-04-07 10:46:14
Stage 2, Now with added acorns.
原文網址 Nick Adam 2018-04-07 10:35:54
I can't seem to re-set my home position. Re-leveling the bed with paper, then setting Tools -> Z = 0 -> yes is not setting a new home. The printer returns to improper, too high, Z height despite setting new Z=0 Any ideas?
原文網址 Karl Trout 2018-04-07 09:29:39
FYI ALL, I was Prepping a print tonight and On review the very first layer was blank. Almost missed it because the next few layers was the raft. I am sure if I tried to print this it would have failed but it was so easy to miss. Make sure to check your print layers after exporting from the Photon Slicer.. :-) now for another 9 hr print. see whats happens in the morning.
討論主題
發文排行榜
回文排行榜
熱門關鍵字