Anycubic Photon Printer Owners 造訪社團

OK i'ts 36 mm high and needs to be printed at about 70 for the details and this is only at 0.4 layers and not hollowed but it's the first print since i replaced the LCD screen. needed to print something interesting that i had already seen another member succeed at.

翻譯年糕

Is there a way to know the first few layer stick successfully? Listen? Feel? Cos definitely can't see the first layer....

翻譯年糕

As all know, our Resin Best Setting spreadsheet is one success. Thanks to your collaboration exactly this moment 11 people are reading and learning (the mean is 10).
Now I need your help again to other ambitious task:
The Anycubic Photon Forum
Is one excelent companion tool for this group because of his search capabilities and subjects organization.
Therefore, I invite you all to visit the Forum, register and start to publish. Thank you all.
Link is this:

翻譯年糕

Bad thing about printing multiple pieces at one time, is when one of them fails and the other doesnt... ya just gotta let it do its thing. Bad thing about printing multiple pieces at one time, is when one of them fails and the other doesnt... ya just gotta let it do its thing. 翻譯年糕

sooo.... I put a little resin on a piece of paper and mixed it with some glow in the dark powder. Put it out in the sun and let it cure. Brought it inside and it does glow (as expected). Question for all of you, should I use the rest of the anycubic sample resin and mix it up with the powder to see how it does? Ya know, for science. (If it fails, I will have no resin to print with for the time being)

翻譯年糕

well, I was planning on holding out until I had cash in hand, but after lunching with Karl Trout today, then coming home to find Amazon had one left in stock, I pulled the plug. Photon will be here on Friday!

翻譯年糕

Ahh snap! I’m officially part of the family.

翻譯年糕

Any experience using BlueCast Primer Coat? We had a Var today send us a 100ml bottle of it. Not sure if I want to test it.

翻譯年糕

So I screwed up, a little bit of resin got between the platform and the 2k screen, and the screen snapped right out, snapping the ribbon cable at the joint. I don't think it's fixable.

Where should I go to buy a new screen? Someone mentioned FEPshop but I can't find the Photon on it, also someone mentioned Aliexpress but I can't find it there either. Any help on this?

翻譯年糕

Sort of failed printing this on default settings: https://www.thingiverse.com/thing:2815233

Rather, it printed successfully, but the articulated joints seemed to be fused at certain places. I spent quite a while with a razor trying to pick them apart, and snapped the thing in half. If anyone has tips for printing something like this, let me know!

I might just need to go bigger.

翻譯年糕