Anycubic Photon Printer Owners 造訪社團

How to cure anything.

OK fellow Photonsters.

Here is the poor mans guide to curing a print before you go all out and score that sweet strip of UV LEDs or steal your wife's (or husbands let's not be all old fashioned here), nail curing hutch.

You can simply expose the print to sunlight this will work even on a cloudy day, It will just take a bit longer.

The trick with curing resins is not to over cure as if you do the resin will become very brittle and be prone to snapping.

The best way to learn if your print has cured enough with sun light or a UV light set up is to find an area where you dont mind a mark and try to dent it with your finger or thumb nail, If you can then it's not ready yet, and as soon as you can't dent it it's ready.

It really is that simple so get on out there in the sun with your prints but remember it's good for the print but you may want some sun screen ;)

happy curing folks.

翻譯年糕

Just how clear can a resin print be, Well you may want to check this out...

翻譯年糕

Ok time for a beginner tip Photonsters!

when you get the printer unboxed your gonna start printing, then you will have successful prints, then you're going to get carried away and want to try bigger better.

This is all well and good but look at the size of that Anycubic green they have sent you, not too big is it?

Now is the time to sit down and find out how to hollow and put drain hols in your bigger prints this will make your resin last a lot longer and you can order some more resin, and if it takes best part of a week to arrive you will still have enough of the Anycubic to see you through the wait and research and ask folks for resin suggestions and so on.

so here is a link to how to hollow with Meshmixer (a free program)

https://www.youtube.com/watch?v=ZXu6VYj4Um0

hope this helps you get through the first resin excitement :D and as ever happy printing.

翻譯年糕

Morning Photonsters how are all you new chaps and chapesses doing today and what's the plan? Morning Photonsters how are all you new chaps and chapesses doing today and what's the plan? 翻譯年糕

How long do you leave the prints in IPA for best results?

翻譯年糕

Guys I see many of you guys using B9 software. Is there a profile or setup file for Photon printer ?
How do you add the Photon printer to B9 software , thanks Phtonsters

翻譯年糕

Do you skip the drawings of the models you have made

.photon as a file

翻譯年糕

Big successful print! Hollow solo! My first hollow print. Worked awesome. 100 microns..... can you tell? Still took like 7 hours!

翻譯年糕

Hi guys! Can someone post screenshots of default anycubic slicer support settings? For top/middle/base and for all 3 low/medium/high density? I think I overwritten them and also with disinstall/reinstall they are modified....

翻譯年糕