Anycubic Photon Printer Owners 造訪社團

Monocure rapid white yet again printed fine but left a thin layer cured at the bottom of the vat. I can’t figure it out. I plan on tackling it this weekend to find the perfect cure times to try to maybe eliminate it. Cleaning the vat for every print isn’t fun.

翻譯年糕

Longest print so far ?

翻譯年糕

Dose this mean it now's it's not there and not printing it

翻譯年糕

Ok I am coming to the conclusion that the failed prints i have seen are a result of bad stl files if you run the stl files through meshmixer on regular settings hundreds of errors are shown and fixing them results in losing many part of the original stl so if your trying to print an stl from an outside source I.e. thingy verse check the files integrity first, Most are very good some are un printable without major restoration work in a 3D editor.

翻譯年糕

hello

What do people think of the best resin please

I know newbie question is
3Dokay Resin any good

翻譯年糕

Stupid question looking in to monocure clear resin. Can you dye the resin to get a clear color like see though blue lol I tried googling but came up dry

翻譯年糕

Calibrating Monocure Rapid Blue... ? ? What's best in the comments...????

翻譯年糕

My company become FEPShop reseller.
I already ordered FEP 150 sheets for Photon, next I'll order for Wanhao D7.
WD7 users, what's the best FEP for your printer?

翻譯年糕

Hey Guys! Thanks for the add, this place is great!

While Artur Fuste 's table is a great resource, is there already a brand of resin that is considered best (considering price vs quality)?

翻譯年糕

Ok, so this has happened twice now and it's really annoying every time i do a tall print say over 100mm it gets to about 62% and just stops I ignored it the first time and put it down to my inexperience but now im angry there seems to be a problem with the size of model I can print and I am not sure why it's also frustrating as I was over 11 hours into the print. Any ideas as to what's causing this problem?

翻譯年糕