Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Good Morning everybody! I have some questions in regards to a print I have been wanting to do.
I have been attempting to print out a Switch dock with the Anycubic Black resin and know the settings are a bit different for it.
I have the settings here and well the result and I am seeing "I am clearly doing something wrong here q.q I usually print out minis but I wanted to try something else for the holidays.

The supports came from the plate while the other was in the vat.
Settings:
Layer Thickness:.025
Normal Exposure Time: 7.5
Off Time: 3.5
Bottom Exposure Time: 90
Bottom Layers: 3

also looking through the forum and get answers but I also wish to know where to educate myself on the settings, ill of course look through google but wondering if there is any recommendations. Its uh overwhelming sometimes XD

翻譯年糕

So this is the first time I am printing something this big roughly and while I am all down to experiment I am running low on resin til next week haha. Something like this do I need to change the settings? I duplicated the model to save on time, should I not do that?

翻譯年糕

It hasnt quite been a problem as of yet as my prints are coming out fine, i am seeing this and i am not sure how to remedy it or if its something to worry about.

翻譯年糕

Hi everyone! I was wondering if its normal for the build plate to wobble left and right easily after tightening it when leveling?

翻譯年糕