Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Help! I never had any issues with my photon until I decided to update the firmware, after that all of my prints have failed. I went back to the previous firmware and I still get the same failures. I have tried multiple resins, exposures and bed leveling techniques. Not sure how visible this is but this supposed to be thick support and it looks really thin. Anyone had some similar issues?

翻譯年糕

Resin that I've put in my photon last night got harden and now it's fused with my vat but it's still liquid underneath. Any idea how to remove it? I'm talking about few mm of solid material on top.

翻譯年糕

My Rocketeer :)

翻譯年糕

First test of my new model :)

翻譯年糕

Some new stuff I'm working on these days. Prints are not that great because I'm using my 3d-okay resin (bad batch).

翻譯年糕

These days I've tested the default Anycubic green, Wanhao black and clear and 3D-okay's black and grey.
Anycubic green and Wanhao resin works great, haven't had failed prints and I've used the default options. 3d-okay (or not okay): had 12 attempts so far, only one almost successful print but has some issues as you can see (Thanos) and on a few places support wasn't even connected. I've tested every setup in that excel sheet. To me that resin and the results look like it's watered down, everything is coming out without any volume, thin and see through. Most of the prints end up like on the images where support is on the plate and the rest if the print is in the vat. Any advices, should I try crazy exposures like 20+?

翻譯年糕