Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi all. I have one of the first photons. I have upgraded my computer and the only slicing software I get is Photon Workshop 2.1.20. Will this work and do I have to change any of these settings:

大家好. 我有第一個光子. 我已經升級了電腦, 我得到的唯一切片軟體是photon workshop 2.1.20. 這個工作, 而且我必須改變以下任何設定:

· 查看原文 · 為此翻譯評分

I have been using FTD Ashy Grey recently without any major issues. I need to buy new resin and I can get FTD again but Monocure Rapid Grey is much cheaper. Should I stick with FTD or go for the Monocure?

翻譯年糕

Michelangelo's Pietà. Printed at 0.03 with FTD ashy grey. Very happy with the results even though some of the fingers didn't print 100%. Model from https://www.myminifactory.com/…/3d-print-pieta-in-st-peter-…

翻譯年糕

My Wanhao green was nearly finished so I just added FTD ashy grey and it printed fine! Haven't emptied my Vat in ages....I just fish out the pieces of cured resin. I always get jelly-like resin in 2 places in the Vat....only after a print. I think it is uv leaking slightly.

翻譯年糕

I've searched hi and low for .stl's of these minis. Anyone perhaps know where I can get them?

翻譯年糕

Some recent prints. Printed in Wanhao Green and then sprayed with grey primer.

翻譯年糕

Printing overnight....
I want to do a 5hr print overnight. It will however hav e to hang there for at least 2-3hrs before I get up in the morning. Will this be OK?

翻譯年糕

Just finished my free bottle of Anycubic Green. Great prints all round! Cannot find any more Anycubic so bought Wanhao Green. Used the settings as per spreadsheet (0.05/7/4/50/8)...Disaster! Most of the supports, especially 1mm ones did not print. Bed adhesion and bottom layers was great!
After searching this page I made the following adjustments: 1) Shook and shook and shook the resin until my tennis elbow returned 2) Changed the normal exposure from 7 to 8. Print came out much better but still some of the smaller supports missing (not even stubs on the bottom layers).....and the print remains tacky long after print and post-curing.
Any advise please!

翻譯年糕

Due to frequent power interruptions in our area I use a 12V DC battery and DC to AC inverter to run my printing (UPS). Is it essential that the inverter be a "pure sine wave" inverter (much more expensive than mod wave inverter).

翻譯年糕

I bought my Photon mainly for printing master models to be used in the manufacture of rubber molds. I have been using FDM prints for the last 4 years but the post processing is very time consuming! It has been a bit of a learning curve but I can at last say I am very excited and happy with the quality and detail of my first printed master! (for a soap mold). ?

翻譯年糕