Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Bad LCD or something else? Two perfect lines that cut across the LCD.

翻譯年糕

This print has come out fine multiple times but the last two times, this has happened. It's not the same spot either. It just stops printing and hardens resin on the vat. Supports are intact on plate and no peeling. Any ideas?

翻譯年糕

Is this a part with not enough support? It seems to me like the plate shifted during the print.

翻譯年糕

Been waiting two weeks now for a replacement touch screen from Anycubic and tracking still doesn't show it's left China. This is ridiculous.

翻譯年糕

Anyone aware of a non-Anycubic parts retailer? My touchscreen has gone belly up. I've checked all the connections and cleaned/replugged everything and the screen keeps registering a touch in a specific spot. Anycubic support is terrible and just drawing this out

翻譯年糕

Touchscreen is not registering touch and "pushing" one specific area. I've cleaned it, no luck. Anyone have any documentation or videos on how to replace this part?

翻譯年糕

Question about using resin to bond pieces together. For pieces that are "slotted" (tab goes into slot). How deep will UV cure, or is it surface only?

翻譯年糕

I've gone through this group a couple of times and not seeing anyone else that has run into this issue: I can't select gcode files from my USB to run. They are loaded on there, but when I go to print, they are not shown. Is a firmware update needed?

翻譯年糕

At my wit's end with this machine. My initial prints were great but now, everything peels off the plate. I've increased exposure time and sanded the plate and I'm using Anycubic resin. Any other ideas I haven't tried?

翻譯年糕

Well, shoot... first couple of prints were great and I just had my first failure. Sorry for the blurry picture, but this is supposed to be the cylinder for a revolver. You can see that it significantly warped during printing. What would have caused this? The support was firmly attached to the build plate. Once it warped, it continued the print normally. I suspect it was the weight of the print and not enough support, but wanted to ask opinions.

翻譯年糕