Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi everyone, is anybody interested in buying some unopened resin? I have two bottles of white and two bottles of grey. I purchased them in December 2018. I'm looking to move them all at once. I'll sell the whole lot for $80 and will pay for shipping. PM me if interested. US only, please. Thanks.

翻譯年糕

I just started printing models in Anycubic white for the doctors presentation models. I notice that if I put them under the UV light they turn brownish. Does the white resin need curing or can it do without it? If it does need curing is there anyway to prevent the discoloration?

翻譯年糕

Hello, folks. I've purchased my Photon to back up my Form 2. Our application is for dental use. I'm trying to calibrate my printer to get as close to scale as possible but when I print my little test file, which should produce a 5mm square I'm always off by .29 to .32 mm (5.29mm or 5.32mm) I've run numerous settings but the scale doesn't seem to change. I'm using the Grey resin. Any suggestions on which settings mostly affect scale? My last set of settings were 0.1, 9.2, 3, 70, 15

翻譯年糕

Hi everyone, thanks for the add. I just received my Photon this morning and am trying to complete my first print. Unfortunately the test file didn't stick to the build plate. I've leveled it out again this time making the paper a little tighter to see if that helps. I'll let you know how it goes and perhaps ask for some advice if needed.

翻譯年糕