edit: I'm having another go at this during the weekend after having to clean out the tank AGAIN! Could it be the contact depth? Its set at 0.20 at the moment. the resin was sold to me as high detail so maybe the finer detail causes finer supports and contact points which aren't upto the job?
Hi folks. I hope someone can help. I’ve been successfully printing using the Anycubic blue that came with the printer and then also the white with very little failures and if they did I know what the problem was.
But I recently bought fun2do ash grey and just can’t get it to print correctly. I used the settings that the company that sold it to me sidestep but still I must be missing something. One part of the print failed completely and dropped off leaving just the supports, the other looks like it shifted or something half way. Well I suspect the supports which where ok on the other resins may need to be thicker? Or something else. I’m at a loss here!
翻譯年糕
Richard Shapiro
2019-01-07 03:57:50
Zena Andreou
2019-01-07 04:04:28
Matt Sofar
2019-01-07 04:09:56
Zena Andreou
2019-01-07 04:19:10
Matt Sofar
2019-01-07 04:21:24
Matt Sofar
2019-01-07 04:26:05
Zena Andreou
2019-01-07 04:32:27
Matt Sofar
2019-01-12 18:39:52
Zena Andreou
2019-01-12 18:56:43
