ISSUE SOLVED - SEE MY LAST POST:
My Photon has started to do the following. when it moves down to the print start height there is a noise as though it is trying to go lower, the screen stays on 1% and no image shows. If I run it 'dry' with the empty vat in place and the plate mounted then it goes down, no noise and the images start as expected. I have done the Z=0 twice now. It started this after a print was completed successfully. Is the resin giving just enough resistance to cause it to not reach the print start position. I changed to a different resin with the same result.
Am I making the Z=0 position too low?
Any thoughts.
I have had the Photon for about 20 months without any printing problems.
翻譯年糕
Spike Walker
2019-08-18 14:56:23
Ray Pilgrim
2019-08-18 14:57:49
Ray Pilgrim
2019-08-18 15:09:32
Niall Forrester
2019-08-18 15:10:49
Ray Pilgrim
2019-08-18 15:11:27
Ray Pilgrim
2019-08-18 15:14:57
Ray Pilgrim
2019-08-18 15:34:45
Steve Roberts
2019-08-18 15:37:27
Ray Pilgrim
2019-08-18 15:42:18
Ray Pilgrim
2019-08-18 15:48:18
David Samson
2019-08-18 15:59:35
Ray Pilgrim
2019-08-18 16:05:15
Ray Pilgrim
2019-08-18 16:06:16
David Samson
2019-08-18 16:10:58
Ray Pilgrim
2019-08-18 16:17:30
David Samson
2019-08-18 16:22:16
Ray Pilgrim
2019-08-18 16:23:48
David Samson
2019-08-18 16:24:24
Ray Pilgrim
2019-08-18 16:25:36
David Samson
2019-08-18 16:27:34
Ray Pilgrim
2019-08-18 16:58:18
Spike Walker
2019-08-18 17:02:45
Ray Pilgrim
2019-08-18 17:03:38
Ray Pilgrim
2019-08-18 17:13:29
Niall Forrester
2019-08-18 17:58:35
Niall Forrester
2019-08-18 18:03:02
Ray Pilgrim
2019-08-18 18:16:42
Niall Forrester
2019-08-18 18:18:14
Niall Forrester
2019-08-18 18:19:26
Ray Pilgrim
2019-08-18 18:20:22
Ray Pilgrim
2019-08-18 18:21:17
Niall Forrester
2019-08-18 18:21:43
Ray Pilgrim
2019-08-18 18:23:04
Niall Forrester
2019-08-18 18:29:33
Ray Pilgrim
2019-08-18 21:04:55
Daniel Prows
2019-08-19 00:13:09
Ray Pilgrim
2019-08-19 15:58:16
Niall Forrester
2019-08-19 22:23:32
Ray Pilgrim
2019-08-20 12:18:54
Ray Pilgrim
2019-08-20 16:03:08
Niall Forrester
2019-08-20 16:11:21
