Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anyone in the Boise area in this group? I have some monocure flex and rapid clear I wanna get rid of. Both are a little over half full.

翻譯年糕

First time trying the monocure rapid clear and flex 100. About 25% flex resin. This was my second attempt with the parts angled in orientation (first time they were flat to the build plate thinking it may have been a suction issue?). Parts ended up being stuck to the FEP both times.

Settings I used:
layer height .5
exposure 11
off 1
bottom exposure 60
bottom layers 5

On the bright side, the flex (durometer?) was really good. I got this machine primarily for flexible materials so I can't wait to get it dialed in. Any thoughts?

翻譯年糕

Hey All - posted a print a few weeks ago with the consensus being z wobble as the issue. I followed the z wobble fix videos on YouTube, got to the eccentric nut, and ran into a couple issues. First, I was unable to even budge the screw that holds the middle pulley on the front. Second, the eccentric nut doesn't have the two additional holes as shown in the videos. I removed the set screws to see if I could get any additional leverage to loose then nut, but no luck. Any suggestions or should I try to get my hands on another part from Anycubic?

翻譯年糕

First print was a success although I was wondering if you all had any insight as to what may be the cause of the layer lines. They’re not tactile - only visual.

翻譯年糕