Hey everyone, I’ve been struggling to get a good print so I wanted to share my issue and see if you have any suggestions.
I’m using the Anycubic white with the following settings in ChiTuBox.
Layer Height: 0.05mm
Bottom Layer Count: 12
Exposure Time: 8s
Bottom Exposure Time: 80s
Light-off Delay: 1s (I think this defaults it’s to 6.5s from what I read)
Bottom Light-off Delay: 1s (same as above)
From what I read on google and in this group, the plate test flat print not sticking properly means I need to level my build plate correctly and maybe bring it even lower on the Z. When I’m leveling it there is some resistance, however I could probably go a bit lower with lots of resistance to the paper.
The second issue I’ve had with 2 different attempts. There is a line in the print:
Picture of the print WITHOUT supports: it’s quite visible as it’s even made a gap.
Picture of the print WITH supports: a load of supports failed at the same time.
This issue I think was caused by me pausing the prints as that’s roughly where I paused them to check if it’s going well.
However the second issue might be not as bad once I fix the first problem. Currently I’m planning to try and lower the plate even more, then do another test with the same flat print in the pictures and video.
I’ll keep updating this until I get a good print out, thanks for reading!
UPDATE: Print successful. Issues were not properly leveled plate which was also not low enough and pausing during the print process. Settings in ChiTuBox were fine.
翻譯年糕
Zena Andreou
2019-02-17 20:24:51
Dimitar Chervenyashki
2019-02-17 22:43:54
Dimitar Chervenyashki
2019-02-18 06:17:20
Zena Andreou
2019-02-18 06:28:47
Dimitar Chervenyashki
2019-02-18 06:32:41
김경록
2019-02-18 14:47:27
Dimitar Chervenyashki
2019-02-18 20:49:49
Dimitar Chervenyashki
2019-02-19 02:02:57
