Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Josh Kale
2018-12-10 08:29:51

One full day of printing down and the lady is complaining about the fumes. I have the printer in our large basement but you can still slightly smell the resin upstairs, so I need to start looking into filtering options.

What do you all use? Unfortunately I have no outside access or vents in the basement, so I'm trying to find another way to filter the smell. Any advice would be tremendously appreciated. Thanks!!

翻譯年糕

Chad Elstad
2018-12-10 08:56:51

Jay Stein
2018-12-10 09:20:26

Jay Stein
2018-12-10 09:21:40

Jay Stein
2018-12-10 09:22:14

Jay Stein
2018-12-10 09:22:57

Antonio Robbins
2018-12-10 09:26:12

Josh Kale
2018-12-10 09:51:27

Che Fielding
2018-12-10 09:58:32

Jay Stein
2018-12-10 10:02:29

Josh Kale
2018-12-10 10:08:08

Josh Kale
2018-12-10 10:08:38

Antonio Robbins
2018-12-10 10:24:07

John Oomen
2018-12-10 20:02:53

Jeff Timothy
2018-12-11 13:02:49

原文網址 Josh Kale
2018-12-09 10:38:35

Hi folks! I've just received my Photon and am incredibly excited to get going! My initial test print of the cube is almost finished and appears to be coming out well. In the meantime I've been attempting to slice some MWO figures from Thingiverse.

The issue I'm having is after I add supports and slice the file I'm reading it into the Photon File Validator, and it appears that no matter which way I tilt the print I'm getting a lot of 'Unsupported Islands'.

Being very new to 3D printing in general, I'm not sure how concerned I should be with this issue. Does anyone have any advice on how I should be looking to resolve it? Thanks a ton!

翻譯年糕

Jeremy Hartman
2018-12-09 10:45:34