Hello. Today I got my printer. I level the bed as shown in the guide. When checking with a hand, there is no loophole along the Z-axis. This is my first print attempt. Everything looked fine, but after the printout finished, I noticed that the detail is distorted and has visible layers much larger than 0.05. What could be the reason? I forgot to mention that I made 2 pauses at the beginning and in the middle of the printout to check if everything was OK.
翻譯年糕
Logan Montreuil
2019-01-12 22:47:47
Lex Cole
2019-01-12 22:52:22
Иван Русковски
2019-01-12 22:53:05
Ilja Ilmar
2019-01-12 23:06:18
Ilja Ilmar
2019-01-12 23:16:14
Иван Русковски
2019-01-12 23:26:01
Иван Русковски
2019-01-12 23:29:36
Greg Fiske
2019-01-12 23:31:54
Robert Pope
2019-01-12 23:44:31
Tycho Pandelaar
2019-01-13 01:29:25
Tycho Pandelaar
2019-01-13 01:30:33
Danny Lloyd
2019-01-13 01:40:55
Lex Cole
2019-01-13 01:43:02
Danny Lloyd
2019-01-13 01:44:17
Иван Русковски
2019-01-13 02:02:50
Wesley Dowell
2019-01-13 03:05:48
Ilja Ilmar
2019-01-13 03:40:24
Ilja Ilmar
2019-01-13 03:42:48
Wesley Dowell
2019-01-13 05:03:27
Richard Shapiro
2019-01-14 01:50:34
