Hey all, sorry if this has been asked a billion times, but does everyone use the default slicer program that comes with our Photon printer? I still have mine in the box, so I haven't set it up yet, but was curious. I have simplify 3D, but I understand that's not compatible for SLA printers(bummer). Ive seen a few alternatives, but wondered what the general consensus was.
翻譯年糕
Justin Cupitt
2019-12-30 00:08:27
Marcin Jażdżewski
2019-12-30 00:10:16
Jlee Usn
2019-12-30 00:11:12
Rick Hanson
2019-12-30 00:11:46
Ryan Pennington
2019-12-30 00:11:59
Keith Yinger
2019-12-30 00:14:25
Luca Malisan
2019-12-30 00:22:48
Jason Pedersen
2019-12-30 00:42:16
Will Koehler
2019-12-30 00:43:35
Jason Pedersen
2019-12-30 00:43:38
Jason Pedersen
2019-12-30 00:44:25
Shawn McDonald
2019-12-30 01:08:50
Shawn McDonald
2019-12-30 01:09:29
Geoffrey Ian Ward
2019-12-30 01:49:42
Luca Malisan
2019-12-30 02:33:11
Justin Cupitt
2019-12-30 02:41:12
Antonio Regidor
2019-12-30 03:27:58
Keith Yinger
2019-12-30 04:03:25
Callum Sidley
2019-12-30 04:15:11
Callum Sidley
2019-12-30 04:17:03
Jarin Udom
2019-12-30 04:18:32
Haydn Nelms
2019-12-30 05:32:26
Sean R. Lake
2019-12-30 05:44:47
Thomas Wright
2019-12-30 07:25:32
Matt Sconce
2019-12-30 13:32:13
Sean R. Lake
2019-12-30 13:35:49
Sean R. Lake
2019-12-30 13:36:22
Daniel A Trisler
2020-01-01 00:29:36
Daniel A Trisler
2020-01-01 00:30:27
Keith Yinger
2020-01-01 00:48:33
