Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Tom Allen
2019-10-06 01:33:23

hi guys, recently got a photon and tried to print this straight to the bed. No luck all that happened was it stuck to the fep. So i turned to the trusty cube and ran that which worked well. Is my original print possible to do straight to the bed or will i have to run them with supports. They are very small, approx 4mm long and 2.5mm wide in a set of four.

翻譯年糕

Tom Allen
2019-10-06 01:34:30

Alex Vee
2019-10-06 01:35:43

Tom Allen
2019-10-06 01:37:40

Nathan Kopp
2019-10-06 01:38:21

Nathan Kopp
2019-10-06 01:39:06

Tom Allen
2019-10-06 01:39:45

Tom Allen
2019-10-06 01:40:59

Nathan Kopp
2019-10-06 01:41:21

Tom Allen
2019-10-06 01:52:01

Tom Allen
2019-10-06 02:18:31

Tom Allen
2019-10-06 03:54:35

Smith Hayward
2019-10-06 17:00:41

原文網址 Tom Allen
2019-10-01 21:22:27

Well DHL delivered my brand bew Photon today, so where to start. Do i need a better slicer than the original one, Chitu seems to be the favourite. The resin that came with it is 250ml of green, are there better resins to use?

翻譯年糕

Eric Honeycutt
2019-10-01 21:25:25

Tom Allen
2019-10-01 21:26:50

Chris Beaumont
2019-10-01 21:28:18

Paul Tyer
2019-10-01 21:34:54

Alexej Sidorenko
2019-10-01 21:36:21

Brian Alexander
2019-10-01 21:42:42

Smith Hayward
2019-10-01 21:44:46

Stephen Lewis
2019-10-01 21:45:07

Smith Hayward
2019-10-01 21:50:01

Stephen Lewis
2019-10-01 21:51:47

James Gibson
2019-10-01 22:08:02

Chris Beaumont
2019-10-01 22:10:06

David Nicholls
2019-10-01 22:24:34

Alexej Sidorenko
2019-10-01 22:32:46

Chris Beaumont
2019-10-01 22:43:59

Matthias Hess
2019-10-01 23:48:56

Mike Roof
2019-10-01 23:55:56

Alexej Sidorenko
2019-10-02 06:56:15

Sean Secretan
2019-10-02 19:53:27

原文網址 Tom Allen
2019-09-19 04:09:12

hi everyone, i've been lurking in the background for a while gleaming bits and bobs of info as they appear. I have one question that i haven't seen mentioned anywhere. Is it possible to extend the z height of the photon, could it just be mechanically done and settings changed, or are the limits pre progammed in the firmware.

翻譯年糕

Adam Burch
2019-09-19 04:17:15