Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Adam Lambert
2019-01-21 05:37:12

Has anyone else has issues with the calibration print cutting off the bottom numbers?

翻譯年糕

Israel Perez
2019-01-21 05:44:31

Adam Lambert
2019-01-21 06:20:32

Israel Perez
2019-01-21 06:22:34

Adam Lambert
2019-01-21 06:47:59

Israel Perez
2019-01-21 06:48:49

Christian Plösser
2019-01-21 06:49:47

Israel Perez
2019-01-21 07:11:07

Adam Lambert
2019-01-21 07:12:47

Kane Wills
2019-01-21 07:29:59

Adam Lambert
2019-01-21 07:33:26

Stefan Giudici
2019-01-21 08:02:31

Stefan Giudici
2019-01-21 08:02:45

Israel Perez
2019-01-21 08:05:42

Kane Wills
2019-01-21 08:39:08

Adam Lambert
2019-01-21 21:28:58

Stefan Giudici
2019-01-21 22:23:52

Sen Kun
2019-01-21 22:27:36

Stefan Giudici
2019-01-21 22:28:53

Adam Lambert
2019-01-21 22:51:13

原文網址 Adam Lambert
2019-01-20 23:59:21

Need help! Suggestions for correcting this failed prints?

Background info

I am using monocure grey resin, 0.025um layer, 8 exposure, 6.5 off, 60 bottom exposure, 5 bottom layers.

I shook the resin quite a lot. Printing in 18.9°C room. I have a brand new FEP sheet tightened to 300hz. And I re-zerod the z axis using paper, I was tight enough I couldnt pull the piece of paper our but not easy push it back in. I am using chitubox for supports and hollowing, and photon slicer to slice.

翻譯年糕

Dustin Scott
2019-01-21 00:09:22

Adam Lambert
2019-01-21 00:17:15

Adam Lambert
2019-01-21 00:18:21

Fred Breton
2019-01-21 14:39:20

Rene Hellemons
2019-01-21 18:59:43

原文網址 Adam Lambert
2019-01-15 21:57:36

I'm having printing problems. As of now the parts are often pulling away from the supports mid print. I am using monocure green resin with an exposure time of 16 seconds. All the parts I am printing are small, miniatures for table top games.

I have replaced my FEP film, rezerod the z axis several times (I use a piece of paper and lower the bed until I get resistance), tried different programs for adding supports (both automatic and manual) but I am not able to figure out how to correct this problem. Does anyone have suggestions?? Any help or advice is appreciated.

翻譯年糕