Would really appreciate the wisdom of the group on this issue. First print using the included clear green resin and the test cube. Read the FAQ and all guidance before set up, so I paid extra attention to levelling etc. and all looked good... Until just over a third of the way through the print when I found it attached to the FEP. Clearly an adhesion/suction issue, but given it's the standard resin with the standard recommended settings I'm at a bit of a loss as to what went wrong and what to fix!
翻譯年糕
Sen Kun
2019-01-24 21:01:38
Christian Plösser
2019-01-24 21:01:48
Trea Cotton
2019-01-24 21:03:18
Christian Plösser
2019-01-24 21:03:30
Sen Kun
2019-01-24 21:04:39
Christian Plösser
2019-01-24 21:05:34
David Ian Fisher
2019-01-24 22:02:30
Sen Kun
2019-01-25 01:02:29
David Ian Fisher
2019-01-26 06:56:46
David Ian Fisher
2019-01-26 06:57:02
David Ian Fisher
2019-01-26 06:59:38
Sen Kun
2019-01-26 13:52:58
David Ian Fisher
2019-01-26 15:30:08
Bob Leschyna
2019-01-26 22:36:57
Sen Kun
2019-01-26 23:16:34
