hi guys, I just clean the grease on the photon but at the end I push 1cm down it was too much so it was stop by the sensor with red light.
My problem right now is that Home position is really to close of the screen. When I press Home position with paper on the screen its impossible to pull the paper out.
So when I try to leveling the build plate the 0 position is higher than the Home position.
Does anyone has a idea to help me ?
Thanks
翻譯年糕
Richard Thomas
2019-03-12 20:13:35
Hugo Robo
2019-03-12 20:15:32
Hugo Robo
2019-03-12 20:28:52
Richard Thomas
2019-03-12 21:10:55
Hugo Robo
2019-03-12 21:15:05
Richard Thomas
2019-03-12 21:19:28
Hugo Robo
2019-03-12 22:46:44
Hugo Robo
2019-03-12 22:47:25
Sen Kun
2019-03-13 00:02:19
Hugo Robo
2019-03-13 00:18:25
Hugo Robo
2019-03-13 00:18:38
Sen Kun
2019-03-13 00:20:56
Richard Thomas
2019-03-13 02:43:09
Richard Thomas
2019-03-13 02:50:03
