Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I am pretty new to this. I have had some issues with prints below .05mm layer height. I have done several tests prints at .05 and things work fine, but the same models fail when I try and set it to a much thinner layer height like .02mm

The prints just don't seem to adhere to the build plate. I am running 60 bottom layers at 70 seconds of exposure each and it still won't stick. I was wondering if this sort of issue might be caused by an error I have made with Zeroing the printer? Have I not zeroed it to the correct tolerance to let it get that close to the film?

翻譯年糕