Hello everyone!
I have made about 10 or so prints on my new Photon so far, and this print has failed in a strange way ... What could cause the layer of thin film around some printouts ? It seems to have cut also the supports on some models.
Im cleaning the FEP before each film (since the 3rd print ...) and make sure there are no residues neither on the FEP nor in the resin (the remaining resin from the VAT is filtered after each print)
Update: it seems that the film is formed even in some areas not having anything to print in the whole volume (even no supports in that area)
翻譯年糕
Hugo Robo
2019-02-04 04:48:21
Giancarlo Arriola
2019-02-04 06:01:14
Nick Williams
2019-02-04 06:38:11
Rémi Mesnager
2019-02-04 06:56:32
Jan Milian
2019-02-04 07:00:06
Jan Milian
2019-02-04 07:01:11
Nick Williams
2019-02-04 07:04:46
Ricardo Sebastian Ibacache Guerr
2019-02-04 07:15:05
Ricardo Sebastian Ibacache Guerr
2019-02-04 07:15:51
Ricardo Frederiks
2019-02-04 13:51:45
Ricardo Frederiks
2019-02-04 14:09:55
Rémi Mesnager
2019-02-05 03:18:31
Rémi Mesnager
2019-02-05 03:19:20
Ricardo Sebastian Ibacache Guerr
2019-02-05 03:20:29
Rémi Mesnager
2019-02-05 03:22:11
Ricardo Sebastian Ibacache Guerr
2019-02-05 03:23:10
