Hi, thanks for the add.
I a compete newbie at 3D printing so looking for some advice if anyone can help, I have setup my photon and done a couple of test prints but they have all ended in the print below.
So couple of questions should the built plate still move once the leveling has been done and the screw in the bracket tightened? what level should the resin be filled to in the bed? And any recommendations on how long a cure time I should use for the first few layers of printing
Thank you
?
翻譯年糕
Dustin Scott
2019-01-09 03:03:07
Aaron Albert
2019-01-09 03:09:24
Stuart Bann
2019-01-09 03:10:20
Joey Smith
2019-01-09 03:16:12
Sen Kun
2019-01-09 03:43:25
Aaron C Plante
2019-01-09 03:50:05
Stuart Bann
2019-01-09 04:00:50
Mike Olsen
2019-01-09 04:17:07
Stuart Bann
2019-01-09 04:18:15
Mike Olsen
2019-01-09 04:20:08
Sen Kun
2019-01-09 04:27:48
Stuart Bann
2019-01-09 04:41:17
