Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Storms are hitting here hard with high wind, thunder, and lightning (typical Kansas summer night). I'm about 6 hours into an 8 hour print. Crossing fingers I don't have to restart a print for the third time this summer due to power flickering.

Really should put the ups on that thing...

翻譯年糕

Those of you who print Heroforge miniatures, I've discovered using the Anycubic resin the mini's come out very brittle and easy to break. I think I've seen it mentioned in here before that some people had mixed another resin in with it to reduce that brittleness? Looking for someone with information on that.

翻譯年糕

Found this interesting. This is Anycubic white after I forgot to take it out from under the UV light for 8 hours (overnight). Doesn't really matter to me since I'll paint. Shown next to white base for color change comparison

翻譯年糕

I've had mostly good luck printing my Heroforge figures recently. However anytime I have more than one, I get a failure. Typically sticks to the FEP and end up pulling flattened pieces. Any suggestions?

翻譯年糕

Finally ran through my first bottle of resin with this awesome printer. Ready to order some more and looking for a variety. Thinking I'll definitely pick up some Monocure Gunmetal and Clear. Also looking for some type of semi-transparent blue. What are some of your favorite resins with this printer and where do you order it?

翻譯年糕

Recommendations on a cheap curing box or a DIY setup, please.

翻譯年糕

It may be a little hard to see in these photos but there is a line in the print (my third print). I believe that is where I paused and restarted the print. That's normal, correct? Also, every time the print lifts for the next layer, there is a small clicking sound as if the layer is sticking to the print basin. Normal as well?

翻譯年糕

Noob question for those with enough experience to answer. How many miniatures prints can you typically get with a 500ml bottle of resin? I know that it will vary based on the model and supports. Trying to get an estimate of resin price per (28mm) mini print.

翻譯年糕

So, yesterday was my first day with the Photon. Got set up and got a good first print. Haven't cleaned it all up yet. What are some of the important things to know as a new Photon owner? I've only had the Monoprice Mini before.

翻譯年糕

My first print. I missed putting a support on the loincloth cloth but rather impressed. What's the best way to go about priming and painting this material? (Heroforge model)

翻譯年糕