Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Scott Johnson
2019-05-11 09:32:43

So— I’ve disassembled, cleaned, reassembled the plate, changed fep, tightened, loosened, tried angling print at varying degrees, played with diff exposure settings—still getting these intermittent lines. Any other ideas?

翻譯年糕

Greg Jones
2019-05-11 09:36:13

Matt Wessel
2019-05-11 10:02:10

Jose Elizondo
2019-05-11 10:11:00

Scott Johnson
2019-05-11 10:12:25

Keith Holmes
2019-05-11 10:19:29

Scott Johnson
2019-05-11 10:23:14

Keith Holmes
2019-05-11 10:50:24

Jawad Abuasabeh
2019-05-11 11:22:04

Kuba Kalinowski
2019-05-11 16:24:47

Ian Robinson
2019-05-11 17:42:07

Scott Johnson
2019-05-13 06:14:37

Scott Johnson
2019-05-13 06:15:30

Scott Johnson
2019-05-13 10:37:10

Sébastien Guilbaud
2019-05-13 21:02:44

原文網址 Scott Johnson
2019-04-15 13:55:21

So—might be hard to hear this... I put the mic right up to the printer so mostly you just hear fans, but if you listen, you’ll hear the stepper start turning, the “click” as the print separates from the fep, and then, on the descent three low clunks, that can also be felt vibrationally thru the printer just befor the print settles for the next layers. Any ideas where I should start looking to troubleshoot?

翻譯年糕