Hello! Calling for help/insight on some failed prints.
I switched resins and added a lot of Flex, and I'm pretty sure I know what the issue is with these prints but wanted to confirm with people here. I keep getting fails and I'm assuming its due to under-exposure?
I've gotten successful prints with the same supports and file (for one of the prints) on a different resin.
I was hoping to get other people's inputs to either confirm my suspicion or correct me if I'm wrong so I can fix the issue.
It seems like certain places the supports don't stick and it leads to the lower body on the hobgoblins not printing correctly. Even on a semi-success goblin print, the back legs (which is the lowest part of the print when I tilt 45 degrees) is misshappen.
Appreciate any insight people can offer. Thanks!
翻譯年糕
Sam Ellis
2019-07-11 15:47:24
Susan Sioux Mercer
2019-07-11 15:48:34
Greg Chapman
2019-07-11 15:49:38
Violet Fer
2019-07-11 16:00:14
Jeff Lee
2019-07-11 16:16:51
Violet Fer
2019-07-11 16:36:39
Jeff Lee
2019-07-11 16:45:00
Björn Plutka
2019-07-11 16:46:41
Violet Fer
2019-07-11 16:56:15
Gregorey Savieo
2019-07-11 17:17:17
