Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Siraya Blu resin:
I've done a few test prints with this, but living in Sweden, and the workshop temperature is somewhere around 21 degrees celsius (70 degrees F), I am having issues with curing times.

I've gotten the model out of the printer, used the spreadsheet, and it holds together, but it doesn't seem to want to cure in my chamber.

It is a bit soft when it comes out of the printer, do you guys have any suggestions for print times? Should I increase bottom and the rest of the layers to get it more cured inside the printer?

翻譯年糕

For those with Ultrasonic cleaners (preferably in Europe): What do you clean your resin with?

翻譯年糕

I'm almost ready to give up on my Anycubic Photon.
First it took 3 (!) motherboards until I got mine working. It took months with shipping new boards from China as there was issues with it.

After I've finally got it running, and levelled and the prints started to stick, it has now started beeping mid print and from then on, stopped raising the Z-level.

Has this happened to any of you and how did you go about it?

翻譯年糕