I'm starting my adventure with Photon. Do not go against it if the questions are obvious. Why setting the Z-axis zero is only accurate to 0.1 mm. After all, with a layer thickness of 0.25 mm it is 4x the height of the layer. For comparison, in my Ultimaker 2 I set the table height with the accuracy of about 1/4-1/8 turn of the M3 screw which has a pitch of 0.5mm. So there the positioning accuracy is around 0,0625mm
-0.125mm and the layer thickness is 2-3 times greater. When printing SLA, the thickness of the first layer is probably more important. Perhaps the majority of problems with print peeling off result from this inaccuracy.
翻譯年糕
Piotr Serbeński
2019-03-26 22:10:48
Alex Varley
2019-03-26 22:10:53
Piotr Serbeński
2019-03-26 22:21:27
Devin Wallace Simonsen
2019-03-26 22:39:53
Guti Gutmann
2019-03-26 22:45:24
Piotr Serbeński
2019-03-26 22:47:18
Jarrod Smith
2019-03-26 22:48:34
Piotr Serbeński
2019-03-26 22:48:48
Guti Gutmann
2019-03-26 22:51:08
Piotr Serbeński
2019-03-26 23:09:19
Richard Thomas
2019-03-26 23:10:08
Piotr Serbeński
2019-03-26 23:10:45
Richard Thomas
2019-03-26 23:11:33
Piotr Serbeński
2019-03-26 23:11:40
Piotr Serbeński
2019-03-26 23:14:26
Richard Thomas
2019-03-26 23:17:06
Piotr Serbeński
2019-03-26 23:17:20
Richard Thomas
2019-03-26 23:19:30
Piotr Serbeński
2019-03-26 23:27:45
Piotr Serbeński
2019-03-26 23:38:07
