Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Quick question, does anyone know what the basic anycubic resin's temperature rating is good up to? Looking for something that is at least in the area of 100-150c.

Thank you!

翻譯年糕

Well, I got my printer to print again. Got a different flash drive, formatted it with FAT32, and copied this file onto it. Not sure why that would have worked, but it apparently did. I'm going to have to try doing the upgrade to 4.2.5 as well. I think it said I was at 4.2.1.

翻譯年糕

Well, it looks like something is wrong with my Photon. It starts printing just fine, then the Z axis just, stops working. I had to cancel my print. I tried to raise Z with the screen controls, and it wouldn't do nothing, so I started spinning the screw by hand, and it kicked in and started moving.

Do I have a bad motor? This thing was new in the box. Not happy at the moment.

翻譯年糕

Well my first print looks awesome! I’ve got a thing for the proto gnome so I did one at 50%. Pretty happy how it turned out.

翻譯年糕

Hi All, I just got my first DLP printer, an Anycubic Photon. Pretty excited. I have it all setup in my shop, got the leveling done, and the software installed.

Just wondering if there is any document on setting up the params for a print. Some sort of "if you are doing 0.5mm height, use these settings with anycubic resin" type thing. I'm experienced with FDM printers, but DLP is new to me.

Thanks in advance!

翻譯年糕