Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi, anyone ever wondered why the Photon doesn't have end-stop switches? I mean obviously it's not an expensive device compared to most high-end SLA printers, but for us common folks it is not cheap either. It is very easy to ram the top or bottom with the build platform, especially if you are new to these devices.
Since you can't have total control (like disabling peel-motion, locking rail movement, etc.) it seems it is aimed more towards the general user than the tinkerer.

(
before someone mentions the bottom switch:
-the one it has it uses for the leveling reference, not for safety
-with a pressure sensor on the bottom, it would be a cheap fix and would allow for leveling and calibration while function as a safety switch
)

翻譯年糕

Hi,

If i work with half the layer thickness, do i use half the UV time too?
Let's say anycubic green, 8sec for .05 layers, would .025 layers need 4s? maybe 6s ?
Any thoughts?

翻譯年糕

Did anyone try the resin calibration test with a Photon S? I'm thinking about the g-code files that turn on/off the peeling motion.

翻譯年糕

Hi,

Can anyone make a picture of the right side window panel of the Photon, from inside the printer? I'm interested how is it secured. I have a Photon S, and it has different shape panel, and attaches with little protruding clips.

I will make my auto-refill system replace the panel, and in case there is interest in this from mk1 Photon owners, i'd like to see if the same method is applicable or not.

翻譯年糕

Hi All!
Just tried out my Photon S for the first time. So far two failed prints. :-(
Around 1cm printed, then stuck to the vat. So i cleaned, noticed the printer was in a 4 degree tilt, fixed that, and tried again. After the second print came out almost the same (around 1.5cm printed then stuck to vat), and being a technical guy, here is a question to the gurus:

I'm printing a closed cone, with tip facing the build plate, is that possible that simply this 'suction cup' shape actually functioning like one and then tears itself from the build plate?

I quickly learned how to edit the model i downloaded from thingiverse, and i added a 'breathing hole' on the side, will start with this tomorrow morning. Any ideas are appreciated.

thx!

翻譯年糕