After having printed lots of things successfully for several months my fep film got punctured and I had to replace it.
From this on two out of three of my prints are failing. Mostly they don't stick to the build plate at all and remain at the vat bottom as a layer. Other fails are partly sticking parts or strange deformations.
I already leveled my print bed a few times and fastened the build plate. My settings on the Slicer are shown below.
One thing I noticed is that the fep film is not sitting directly on the glas because the screws of the vat are protruding a small amout. Could this cause all my problems? If yes - how to solve this?
Any suggestions are welcome ...
Kai
翻譯年糕
Allan Johansen
2020-01-20 05:02:59
Chris Holden
2020-01-20 06:25:09
Kai Laborenz
2020-01-20 14:27:46
Kai Laborenz
2020-01-21 14:31:51
