Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 James Campbell
2019-07-15 19:21:50

What is the best black resin to mix with monocure rapid flex 100 to use on something like a phone case? Also what ratio is recommended?

翻譯年糕

原文網址 James Campbell
2019-07-08 18:45:11

Any know how to reduce sagging on prints I’m using anycubic green dental and it sags between supports

翻譯年糕

Puren Bulat
2019-07-08 18:54:03

James Campbell
2019-07-08 18:55:48

James Campbell
2019-07-08 18:56:05

Drew Teichman
2019-07-08 23:20:07

James Cachia-Garrett
2019-07-09 03:50:24

Michael S Dooley
2019-07-09 04:42:52

James Campbell
2019-07-09 04:58:40

Timothy White
2019-07-09 06:31:06

Michael S Dooley
2019-07-09 06:35:36

James Campbell
2019-07-09 07:02:53

原文網址 James Campbell
2019-07-02 20:17:06

I’m using anycubic dental green, my first few prints went really well with LT: 0.035mm NE: 8s OT: 1.5s ET: 80s BL: 8. But i re-levelled the bed after updating the firmware as i wanted to test out AA and now all my prints are getting stuck to the FEP. Does the firmware have anything to do with this issue? I’ve re-levelled after every miss print and cant seem to fix it.

翻譯年糕

Bob Deblier
2019-07-02 20:36:42

James Campbell
2019-07-03 05:08:27

Bob Deblier
2019-07-03 14:25:24

James Campbell
2019-07-03 14:29:32

Bob Deblier
2019-07-03 14:30:13

原文網址 James Campbell
2019-07-01 18:06:08

I have just installed ChiTuBox and i am wondering if anyone knows what the default settings are for the original photon (im using the anycubic green dental resin)? i'm concerned about the lift speed they were up at 300mm/min which seems fast? anyone know what a good speed is/ the default speed?

翻譯年糕

James Campbell
2019-07-01 18:10:29

Jason Sankovitch
2019-07-01 21:00:42

James Campbell
2019-07-01 21:06:28

Jason Sankovitch
2019-07-01 21:10:21

原文網址 James Campbell
2019-06-26 07:59:09

Thank you everyone for your help yesterday! I have decided on an original anycubic photon. Hopefully z wobbles will not cures me ?

翻譯年糕

原文網址 James Campbell
2019-06-25 13:04:34

I’m looking to buy a 3d printer to make jewellery. Reliability and quality of both the printer and prints are priority as i don’t want to be constantly troubleshooting. I’m tossing up between the phrozen shuffle, anycubic photon and epax x1.

Does anyone have experience with these printers to recommend which one i should get.

翻譯年糕

Shayne Webb
2019-06-25 13:55:40