Hello everyone.
So yesterday morning I set up a print and my miniatures were sliced right in half. (It was comical actually it looks like my miniatures walked through a laser) Sure enough only half of the LCD was coming on when I tested it.
I shut my photon down then tried it again and it worked. Printed the rest of the day probably 20+ figures without a single problem.
My photon is only about a week old should I be worried about this one occurrence or is this just a glitch?
Thanks
翻譯年糕
Sen Kun
2019-04-30 02:03:51
Stefan Giudici
2019-04-30 02:08:55
Ricardo Solano
2019-04-30 02:11:02
Ricardo Solano
2019-04-30 02:42:32
