Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Adam Wiseman
2020-01-14 06:12:33

Can anyone help with what's caused these cracks to appear on my progress, I'm assuming it's a heat thing because it's been more then 30 degrees most days, but I'm unsure. They were fine for the last couple months then yesterday I noticed the two big cracks had come from nowhere

翻譯年糕

Herllon Alves
2020-01-14 06:16:22

Peter Csaki
2020-01-14 06:20:17

Sander van Deijl
2020-01-14 06:21:15

Sander van Deijl
2020-01-14 06:23:01

Adam Wiseman
2020-01-14 06:24:58

Shreyo Bagchee
2020-01-14 06:54:00

Justin Cupitt
2020-01-17 23:57:05

原文網址 Adam Wiseman
2019-12-18 04:57:50

Any suggestions what would be causing this separation, this is the second one of these I've printed though the first printed fine,my best guess is that it's adhesion to the FEP which is why it follows the angle it's printed on.

翻譯年糕

Scott Pavlich
2019-12-18 05:18:57

Fred Bey
2019-12-18 10:16:54

原文網址 Adam Wiseman
2019-07-25 16:48:03

I've been using the monocure rapid clear to print miniatures, but because it's so clear it can be tough to see the details before priming them. Has anyone got any suggestions on good alternatives?

翻譯年糕

Klaus Teschner
2019-07-25 16:53:26

Greg Chapman
2019-07-25 17:07:23

Scott Pavlich
2019-07-25 21:48:22

Mike Foreman
2019-07-25 23:26:06

Clifford Schwankner
2019-07-26 05:16:06

原文網址 Adam Wiseman
2019-07-04 21:21:23

So this printer has been a bit of a Rollercoaster so far,, my initial print of the test cube got stuck to the build plate, but some advice from here helped fix that up. Next when i tried printing some models they got stuck to the FEP, it didn't matter how many times i leveled it. As the cube had printed before I decided to try that again to see if it would fail, or succeed, and instead both times I've tried it I've been rewarded with a perfect disc but nothing else. I'm completely out of ideas, so if anyone can assist that would be much appreciated

翻譯年糕