Hello all. I'm new to my Photon, just have 4 or 5 prints under my belt. I'm having an issue one of my parts. It's a essentially a half circle, with a round socket/hole in the bottom. When it prints, and it's done this twice, it is getting a flat spot on the bottom, that is outside of the print area ov the object. The flat spot is basically parallel to the bed, but it's raised off it by supports.
Any ideas? I'm just getting the hang of how to properly align my prints.
This is sliced using CtiTuBox. Anycubic Green. .05 layer heigth.
Sorry about my grubby fingers.
:)
翻譯年糕
Brad Dudenhoffer
2019-07-04 09:49:37
Jason Britton
2019-07-04 11:09:55
Brad Dudenhoffer
2019-07-04 11:10:45
Brad Dudenhoffer
2019-07-04 11:10:46
Jason Britton
2019-07-04 11:14:18
Stefan Giudici
2019-07-04 11:59:10
Brad Dudenhoffer
2019-07-04 12:14:12
