Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Ian McGiggle
2019-07-18 09:02:08

I just tried my second test print after tightening the bed further, but for some reason one side of the cube wasnt printing. Does anyone know what is causing this? I stopped the print about halfway through when i realized it was malfunctioning

翻譯年糕

Bryan Napes
2019-07-18 09:05:10

Ian McGiggle
2019-07-18 09:08:14

Bryan Napes
2019-07-18 09:08:44

Ian McGiggle
2019-07-18 09:14:04

Bryan Napes
2019-07-18 09:14:33

Ian McGiggle
2019-07-18 09:22:27

Ian McGiggle
2019-07-18 09:25:20

Bryan Napes
2019-07-18 10:04:17

Stefan Giudici
2019-07-18 10:14:22

Ian McGiggle
2019-07-18 10:47:22

Ian McGiggle
2019-07-18 10:47:37

Ian McGiggle
2019-07-18 10:48:01

Stefan Giudici
2019-07-18 19:54:02

Chad Elstad
2019-07-18 23:18:14

原文網址 Ian McGiggle
2019-07-16 10:16:50

Does anyone know what the error "z=zero is decided by the trigger position" means? I am trying to level my bed but any time i try to set the new Z=0 distance I either get that pop up or one that says "Home first, then move Z to bottom!", even if i have already homed and moved it.

翻譯年糕

Craig Underhill
2019-07-16 10:19:02

Ian McGiggle
2019-07-16 10:20:33

Craig Underhill
2019-07-16 10:50:01

Ian McGiggle
2019-07-16 11:06:52

Sen Kun
2019-07-16 11:08:00

Ian McGiggle
2019-07-16 11:24:22

Ian McGiggle
2019-07-16 11:31:31

Sen Kun
2019-07-16 11:45:55

Ian McGiggle
2019-07-16 11:55:55

Sen Kun
2019-07-16 13:18:04

討論主題

全不選常用關鍵字

2 IDE