Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Victor Leznik
2020-03-31 11:18:18

Stumped here - printed just fine the day before now started to be funky. Replaced FEp and re-leveled
Tried various orientation methods and various resin. Super inconsistent.

Just coming off the supports (.3mm contact area)

5 base layers with 90s exposure
10.5s exposure per .02mm layer and 5s off time

翻譯年糕

Victor Leznik
2020-04-01 02:31:40

Thoughts?

Charles Davenport
2020-04-01 06:44:35

Have you adjusted the support parameters? Perhaps the support does not have enough penetration? I had similar problems and went to heavy supports with minimal penetration. As you add supports, you can actually see if and where the support protrudes through the part. You can then edit that depth to gain max support without affecting the finish of the part. If you are unsure how to do this, PM me and send screen shots showing the process. Until then, Good Luck!

Victor Leznik
2020-04-01 06:54:10

Charles strange part is that it worked okay the months prior. No changing factors. LCD seems fine too based on the exposure check

Charles Davenport
2020-04-01 06:59:18

Victor Leznik Oh, Victor! I know what you mean! I have too little hair remaining to pull out over the unreliability of my Photon! I am seriously considering purchasing a different machine. One day my Photon prints fine, the next day, same print...a nd the machine laughs at me! And, I understand the time wasted in testing the same print time after time. Nevertheless, you might try giving those affected supports the "Heavy" treatment. I can't think of anything else in my limited experience. The same exact thing just happened to me. Oh, yes, consider adding more supports than needed. I've done that to good effect. It results in more post-print work, but at least you have a print! Good luck!

Victor Leznik
2020-04-01 07:57:43

Charles - I’ll give it a go! I’ve since updated the software to 4.2.18 with AA and thickened supports. Let’s see what happens! Hoping that dual rails and easy leveling will resolve unreliability as well

原文網址 Victor Leznik
2019-10-02 00:20:08

Any thoughts on how I can avoid “pooling”? Anycubic grey, 11s exposure, 3 off time

Some holest came through, others didn’t ?

翻譯年糕