Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Oke just got my plant based anycubic resin and did the resin xp finder for the photon S..

If i follow the instruction it says to find the first good upper full circle, so in this case thats 3, then go down to the last visible circle and then go up in number till that circle becomes full so that's 5.
But what are all those dots on the right sides? Not visible till 7.. is that the overexposure?

Which one looks best to you?

翻譯年糕

My first printed lithophane.
Anycubic white @7sec exposure time, 5 bottom layers @60sec on a Photon S.

Printed flat on the buildplate in 15min.
My question is: what causes the holes between layers? Is it exposure time?

翻譯年糕

Saw an interesting film about tuning a FEP for tension.
Has anyone used a frequency analyser for tuning the FEP film?
And anyone noticed the tuning was off with the stock FEP at first use?

翻譯年糕

Printed the RERF file for the photon S but it seems that the bottom is increasing in height from right to left? Right is very thin and left is very thick.
Is my buildplate that off? Or something else..
I used the paper method to align.

翻譯年糕

Oké here is a thought.
If you hollow a model then you need to have a hole in the bottom and 1 on top for drain and vent and internal cleaning. So the bottom hole is no problem because it's on the bottom.. but the top hole you need a lot of post processing to fix that. What if you raise the height on your z axis between layers? Just enough to get above the resin bath.. resin will drip out and there is no need for a top hole?
Printing time would be more but post processing is a pain especially with high detail prints..
What are your thoughts?

翻譯年糕