Hi guys,
I've read and tried almost everything.
I own 2 photons and 1 photon S.
I have used ac green, black and siraya blu many times and had very small issues once in a while.
Now, switching to rapid abs like translucent elegoo, it looks like my supports are doing fine the first 4 mm, then they start to thin up and they then disappear. The weird thing is that this happens only with some supports, mostly on the corners.
I have used timings up to 14 secs and 6,5 light off secs, down to 11 and 1.5 LO, but i still get these issues.
Last night i tried to print a small piece with a flat side on top of few heavy supports, starting at 5mms from the plate. After 80 some layers, the supports looked like they had a pointy tip and the photon never printed anything else after that.
What bugs me is that the lcd test worls fine, the rectangle shows fairly well and clear.
Temperature of the room is around 20degrees as i have two chirons working full time next to the photons and they are freaking heaters.
Here you see photos of the pigmented (with cmyk monocure 3d pigments) elegoo resin on both the photon and the photon s.
Also, i have been having these problems since switching to 1.6.1 chitubox software.
Any suggestions is very welcome as I am running out of ideas.
Thank you all for your time.
翻譯年糕
Yi Chang
2019-12-03 16:05:43
Bob Deblier
2019-12-03 16:06:41
Fulvio Pannese
2019-12-03 16:08:59
Bob Deblier
2019-12-03 16:09:40
Bob Deblier
2019-12-03 16:10:24
Fulvio Pannese
2019-12-03 16:10:25
Bob Deblier
2019-12-03 16:11:39
Fulvio Pannese
2019-12-03 16:13:09
Samson Chen
2019-12-03 16:19:52
Fulvio Pannese
2019-12-03 16:23:45
Fulvio Pannese
2019-12-03 16:26:00
Fulvio Pannese
2019-12-03 17:37:28
Fulvio Pannese
2019-12-03 17:38:15
Bob Deblier
2019-12-03 17:38:33
Fulvio Pannese
2019-12-03 18:26:57
Alexander Keith
2019-12-03 23:23:47
Fulvio Pannese
2019-12-04 04:42:01
